Wehr Machine Racing Products

Our new swivel cups will keep your springs happy during travel by allowing rotation and angular alignment. They work with our hollow screw jacks or you can run them on a stud on the rear end...

Our new double slot steel climber frame mount for 1-1/2'' square can be flipped either way on the tube to give you three options for J-Bar lenghts in one mount. Mount comes with all hardware.

Lightweight 1/2'' -20 fine thread hood pin with the flange machined on them for the hood to sit on so you don't have to put a rubber hose on the pin. 5'' long from flange to bottom of threads.

Lightweight 1/2'' -20 fine thread hood pin with the flange machined on them for the hood to sit on so you don't have to put a rubber hose on the pin. 4'' long from flange to bottom of threads.

A Wehrs Machine Original Innovation, clamp on mounts for 1/2"-20 hood pins. This is our 8" tall mount for 1-1/2" tube. Height is measured from center of tube to top of mount. See accessories tab for...

A Wehrs Machine Original Innovation, clamp on mounts for 1/2"-20 hood pins. This is our 4-1/2" tall mount for 1-1/2" tube. Height is measured from center of tube to top of mount. See accessories...

A Wehrs Machine Original Innovation, clamp on mounts for 1/2"-20 hood pins. This is our 2-1/2" tall mount for 1-1/2" tube. Height is measured from center of tube to top of mount. See accessories...

A Wehrs Machine Original Innovation, clamp on mounts for 1/2"-20 hood pins. This is our 4-1/2" tall mount for 1-1/4" tube. Height is measured from center of tube to top of mount. See accessories tab...

Rebuild kit for our spring sliders. Includes new style bushing, piston, snap ring, o-ring, and nyloc nut.

This spring alignment plate works with soft rate springs using the 5" OD to align the spring instead of the ID on our coil over spring sliders and our WM285D drop bearing RF...

Our standard slider cups now capture the OD of the spring to keep it more linear through travel. This is the removable side cup.

Replacement shaft for WM251 24" extended slider. Overall length is 12-3/4" and shaft portion is 9-3/4".