Wehr Machine Racing Products

Machined thick wall DOM 5/8" suspension tube with 13/16" hex on each end. Lasered with length and thread direction for your convenience.

Our open style puck pull bar comes with brake separate from the pull side and also has a long bronze bushing to eliminate shaft flex under load. this bar can be built to suit your rate curve for...

12" long heat shrink for limit chain to prevent binding.

12" Long chain for chain limiters

Our new Dirt Late Model legal open style left rear limiter! Limiter has a 1" tall foam to meet the new rules for WoO. This is our limiter with a black foam.

This load stick bolts in where your shock goes on a shock separate suspension. The stick allows you to change springs with ease and accuracy, along with being able to pull the race car down to...

This new David Stremme inspired spring cup raises the spring up to enable you to run the RR shock bulb up and have trailing arm clearance. The cup raises the spring up 3". This cup has a 1/2" hole...

Our new Brad Waits designed quick change limit chain adjuster allows you to change your chain length by simply pulling a pin, moving to the next hole and inserting the pin. You can make a chain...

This new Travis Roth tool lets you instantly know after you crash if you need to change your spindle. Screws on your 1/2" fine thread upper ball joint and plunger points to center of lower...

These are a cross between a bolt and a shock pin. Don't trust the pin? These use a nut, like a bolt would. Spacer part is machined on like the pins, thread is 1/2'' -13 coarse. 2-1/8'' short steel...

This is our new long steel shock bolt with points. Same design as our WM148SL bolt, but we added a point at centerline on each end to easily measure center to center on your shock! Bolt is...