16" X 24" Kneel Pad

No need to let your knees suffer at the shop and at the track with this 16" x 24" kneel pad. 1 1/2" thick foam for extra protection.

Wehrs Hole Spacing Marker

Tool marks hole spacing 1"-6" with both a hole and a point. Edge spacing of 1/4" and 1/2". Comes with a 1"-4" mini version for hard to reach areas.

Wehrs Aluminum Coil Over Wrench Kits

Aluminum Coil Over Wrench  Available for 2.5" and 5" spring cups

Rear End Filler Mud Deflector

the mud deflector is designed to keep dirt away from the rear end filler tank. It is installed using (5) 3/16" small head rivets. Simply rivet the deflector to your deck tin and watch the mud...

Wehrs Fuel Pump Cover

Keep unwanted dirt and dust out of your fuel pump when it is on the shelf. Whether it's your spare in the trailer or your primary in the offseason, keep it in proper working condition with our...

Weld On Screw Jack Mount

This is our weld on screw jack mount for 1"-8 thread screw jacks. Mount has three threaded holes that are 2-1/2" center to center. 

Wehrs Solid Bent Tubes

These are our 5/8'' bent suspension tubes for clearance for the suspension cage. Tubes are machined from solid 4140 billet steel tube for improved strength. Tubes have 13/16" hex on each end.

Tube Wrench Clamp for 5/8" Tube

Adjustments made easy! Grab your 1-1/4" wrench and turn the tube clamp to adjust your suspension tubes. Designed for use with our WM450 Suspension Tube Jam Nuts.Sold seperately is...

Nitro Bee Flat Mount

Nitro Bee Radio mount will mount your radio with Velcro or 1/8" rivets to your helmet or a flat surface.  Nitro Bee Radio not included with bracket.

Wehrs 5" Raised Spring Cup

This new bolt in 5" OD grab Raised cup moves the spring table up 1" from our WM404SC cup.  The OD grab spring cup centers the spring on the outside diameter to keep the...

5" Bolt In Drop Cup

This new bolt in 5" OD grab Drop cup moves the spring table down 1" from our WM404SC cup.  The OD grab spring cup centers the spring on the outside diameter to...

Wehrs Bearing Tool

Install/remove your cage bearings with ease with our all new bearing tool! Use a hammer to tap the handle while the tool does the work. Comes with handle, punch, and ring.