1.5 FRAME MOUNT FOR PANHARD BAR

These slick mounts let you change the length of your panhard bar with ease. Change the length 2-9/16'' by simply swapping bars out.This mount fits 1-1/2'' x 1-1/2'' square tube. This part number is our steel mount.

ALUMINUM DOUBLE SIDE PANDARD SLIDER - 1.5"

Fits 1.5" square tube. One slot on centerline of tube and one slot inboard. Mount has 4-1/2'' total adjustment. Works with climber on arc to keep car tracking lined up. Climber hardware included.

ALUMINUM DOUBLE SIDE PINION MOUNT - QUICKCHANGE

Same arc as our WM205 with the extra arc slot on left side of the pinion. Mount adjusts easily with our climber nut. All hardware included.

ALUMINUM DOUBLE SLOT FRAME MOUNT - 2"

Fits 2''X2'' square tube. One slot on centerline of tube and one slot inboard. Mount has 4-1/2'' total adjustment. Works with climber on arc to keep car tracking lined up. Climber hardware included.

CLAMP ON STEEL PULL BAR BRACKET

Steel Clamp on pull bar bracket for 1-1/2" round tube. Holes are on an arc to keep pinion angle right when adjusting. Comes with 5/8" bolt and spacers to reduce 3/4" heim to bolt.

DOUBLE ADJUSTER - 3/4

3/4"-16 RH and LH double adjuster with 2-1/2" of thread in each direction. 6-1/2" overall length.

DOUBLE SLOT FRAME MOUNT - 1.5 INCH

Our new double slot steel climber frame mount for 1-1/2'' square can be flipped either way on the tube to give you three options for J-Bar lenghts in one mount. Mount comes with all hardware.

DUAL USAGE PINION MOUNT

A Wehrs original concept in pinion mounts to save you some money. This pinion mount is built with 2 identical sides so in the case of an accident you can unbolt the mount, flip it 180 degrees and you have another good side instead of having to buy 2...

PANHARD BRACKET FOR 2" SQUARE MOUNT

Panhard Bar Bracket, Frame Mount, Clamp-On, Steel, Cadmium, 2 in Square Tubing, Each

STEEL ADJUSTABLE J BAR - 18" - 22"

Just like our aluminum one, only made out of steel dom tubing, has two inches of adjustment like the aluminum one - just a little heavier. This bar is our body #1 with a WM40A and is 18''-20''.

STEEL QUICK CHANGE PINION BRACKET

Our new billet steel QC pinion mount. This profile matches our WM219 mount and is machined with the seal installed in it to eliminate the seal plate like our standard steel mounts use. Comes with climber gear hardware.