HIGH MISALIGNMENT SPACERS

WEHRS MACHINE HIGH MIS-ALIGNMENT SPACERS 1/2" INSIDE DIAMETER 5/8" OUTSIDE DIAMETER (ROD END SIDE)

1.5 FRAME MOUNT FOR PANHARD BAR

These slick mounts let you change the length of your panhard bar with ease. Change the length 2-9/16'' by simply swapping bars out.This mount fits 1-1/2'' x 1-1/2'' square tube. This part number is...

Wehrs Small Chevelle Control Arm Bushing

Chevelle lower control arm bushings are lightweight and greaseable for smooth travel. 

Wehrs Chevelle Large Control Arm Bushing

Chevelle lower control arm bushings are lightweight and greaseable for smooth travel. 

STEEL QUICK CHANGE PINION BRACKET

Our new billet steel QC pinion mount. This profile matches our WM219 mount and is machined with the seal installed in it to eliminate the seal plate like our standard steel mounts use. Comes with...

STEEL ADJUSTABLE J BAR - WEHRS

Just like our aluminum one, only made out of steel dom tubing, has two inches of adjustment like the aluminum one - just a little heavier. This bar is our body #1 with a WM40A and is 18''-20''.

DOUBLE ADJUSTER - 3/4

3/4"-16 RH and LH double adjuster with 2-1/2" of thread in each direction. 6-1/2" overall length.

THERMOSTAT RISER 3/8

SMALL SPRING 6TH COIL

This is our new version of the small 2'' diameter spring 6th coil with better adjustability. Uses same spring as our WM291 can style. Available bare or with your desired spring rate. This is the bare...

MOD NOSE SUPPORT KIT

Lightweight 1/2'' -20 fine thread hood pin with the flange machined on them for the hood to sit on so you don't have to put a rubber hose on the pin. 4'' long from flange to bottom of threads.

LOWER GROUND CONTROL CLAMP

This clamps to a 1-1/4" lower tube to fasten your limit chain to.

TIE ROD ADAPTER

Inner Tie Rod Stud