Rear Suspension

Steel shock swivel to eliminate binding. This is the standard block to go to 4'', 5'', and 6'' drops. The swivel is sold separately WM200-8

Zinc Plated Steel Spacer Bushings, 3/4″ OD, 1/2″ ID

Steel swivel for shock mounts. Comes with spacers and nut.

Each Kit includes (2) parts. Kit consists of;  (1) upper and (1) lower 1/2" - 20 stainless steel shock nut with double tapped through hole for 8/32" and 10/32" shock sensor eyelets.  Works on both 1/2" diameter shock sensors and 1" diameter...

Our standard slider cups now capture the OD of the spring to keep it more linear through travel. This is the removable side cup.

Rebuild kit for our spring sliders. Includes new style bushing, piston, snap ring, o-ring, and nyloc nut.

This spring alignment plate works with soft rate springs using the 5" OD to align the spring instead of the ID on our coil over spring sliders and our WM285D drop bearing RF spring cup.  You can also run WM165BO on one end of...

Lots of trickery in our spring sliders. The smoothest and most stable slider on the market. We use a linear DU bushing on a hardened shaft, along with a shaft stabilizing internal piston. No need to unscrew the nut to remove the spring. The spring cup...

Just like our aluminum one, only made out of steel dom tubing, has two inches of adjustment like the aluminum one - just a little heavier. This bar is our body #1 with a WM40A and is 18''-20''.

Steel chain holder with bearing. This keeps the chain bind free through the range of motion

Our new Brad Waits designed quick change limit chain adjuster allows you to change your chain length by simply pulling a pin, moving to the next hole and inserting the pin. You can make a chain adjustment in seconds with no tools. Made of steel with no...

STEEL SWEDGED RADIUS RODS. 5/8-18 FEMALE THREADS, 7/8 O.D. BLACK