Clutch and Driveline

GN Hub Assembly   GN Steel Rear Hub Assembly Complete with: Steel Drive Plate Bearings Races Installed Steel Lugnuts  Long 5/8" Coarse Wheel Studs Rotor Bolts Hub Seal Lock Washer O-Rings Hardware (No Hub Nut)   Weighs 11 lbs.  

Kits include: Steel Drive Flange for GN Hub w/ Black Dust Cover (5x5 Bolt Pattern) O-rings 2 tapered screws 3 allen head screws

Hub Bearing Seal, Rear, Rubber / Steel, AFCO / Allstar / SCP / Winters 2-1/2 in Pin 5x5 Hubs, Each

Lock Washer, Tab, Steel, Zinc Oxide, 2-1/2 in Grand National Wheel Hub, Each

  Axle Housing Seal, Inner, Bellows Style, 0.950 in ID, Rubber / Steel, Natural, 3 in Axle Tubes, Ford 9 in, Each

Axle Housing Seal, 2.625 in OD, 1.125 in ID, Aluminum / Rubber, Red Anodize, 3/16 in Wall 3 in Axle Tubes, Ford 9 in, Each

LOW PROFILE rear end filler tank! This has been designed by racers for racers! We created the low-profile design to eliminate large chunks of dirt and debris knocking the canister loose from the decking. Also, using 100% made in America material, we...

Aluminum fill can. 8" Total Height. 3" Can Diameter. 6"x6" mounting surface. 2 lbs. -10 AN male bottom port. Includes Cap.

Looking for an affordable replacement driveshaft speed sensor? Tired of setting gaps only to find it still isn’t reading properly?   Well, here’s the solution!  built in LED indicator light for setup Triggered by ferrous material...

Breather, Screw-In, Round, 4 AN Tube, Reusable, Steel, Chrome, Each