Wehr Machine Racing Products
WEHRS SPINDLE CHECKER 3 1/4 - 5"
(No reviews yet)
Write a Review
- SKU:
- WM449
- Availability:
- Ships Today
Description
This new Travis Roth tool lets you instantly know after you crash if you need to change your spindle. Screws on your 1/2" fine thread upper ball joint and plunger points to center of lower ball joint if the spindle is straight. Bent spindle shown in second picture.
Related Products
Related Products
Wehrs Axle Checker
Wehr Machine Racing Products
$75.00
Set your axle on and roll to check straightness. We also have a slot on the bottom to mark a straight line on new axles with a sharpie to keep an eye on axle twist.
Wehrs Steel Suspension Tubes - 3/4"
Wehr Machine Racing Products
$21.25 - $31.00
Machined .156'" wall DOM steel suspension tube 3/4"-16 thread with 15/16" hex on each end. Lasered with length and thread direction for your convenience.
Wehrs 5" Raised Spring Cup
Wehr Machine Racing Products
$67.00
This new bolt in 5" OD grab Raised cup moves the spring table up 1" from our WM404SC cup. The OD grab spring cup centers the spring on the outside diameter to keep the...
Wehrs 1" Open Insert
Wehr Machine Racing Products
$51.00
This is the open insert with max power for our 1" tall body.
5" RAISED SPRING CUP - WEHRS
Wehr Machine Racing Products
$110.00
This new David Stremme inspired spring cup raises the spring up to enable you to run the RR shock bulb up and have trailing arm clearance. The cup raises the spring up 3". This cup has a 1/2" hole...
Wehrs Steel Suspension Tubes - 5/8"
Wehr Machine Racing Products
$19.99 - $30.99
Machined thick wall DOM 5/8" suspension tube with 13/16" hex on each end. Lasered with length and thread direction for your convenience.
WEHRS AXLE PULLER
Wehr Machine Racing Products
$33.00
Our Troy Brand inspired T-handle style axle puller removes your axle with ease acting as a slide hammer for tight or bent axles. Fits standard axles with 3/8" fine or coarse thread, and gun-drilled...
Wehrs Bearing Tool
Wehr Machine Racing Products
$80.00
Install/remove your cage bearings with ease with our all new bearing tool! Use a hammer to tap the handle while the tool does the work. Comes with handle, punch, and ring.