Description
Install/remove your cage bearings with ease with our all new bearing tool! Use a hammer to tap the handle while the tool does the work. Comes with handle, punch, and ring.
Related Products
Related Products
Commercial Series Spherical Bearing - Wehrs J-Bar
Wehr Machine Racing Products
$11.99
Replacement monoball for J-bars and lower control arms
WEHRS AXLE PULLER
Wehr Machine Racing Products
$33.00
Our Troy Brand inspired T-handle style axle puller removes your axle with ease acting as a slide hammer for tight or bent axles. Fits standard axles with 3/8" fine or coarse thread, and gun-drilled...
Wehrs Sipe Setter
Wehr Machine Racing Products
$39.99
This is our new Jason Sivils inspired adjustable sipe setter! This cool tool allows you to pre-set your siper depth flat or at an angle to add strength to the trailing sipe blocks. Inner block has...
Wehrs Axle Checker
Wehr Machine Racing Products
$75.00
Set your axle on and roll to check straightness. We also have a slot on the bottom to mark a straight line on new axles with a sharpie to keep an eye on axle twist.
Wehrs Fuel Pump Cover
Wehr Machine Racing Products
$15.00
Keep unwanted dirt and dust out of your fuel pump when it is on the shelf. Whether it's your spare in the trailer or your primary in the offseason, keep it in proper working condition with our...
Wehrs Fixed Measuring Plate
Wehr Machine Racing Products
$144.00
Inspired by Jason Feger, our all-new 'Fixed Measuring Plate' is designed to store measurements of all 4 rear suspension bars. The plate is 3" wide with center to center bar lengths machined on it...
Wehrs Solid Bent Tubes
Wehr Machine Racing Products
$30.00
These are our 5/8'' bent suspension tubes for clearance for the suspension cage. Tubes are machined from solid 4140 billet steel tube for improved strength. Tubes have 13/16" hex on each end.
Wehrs 1" Open Insert
Wehr Machine Racing Products
$51.00
This is the open insert with max power for our 1" tall body.
Wehrs Hole Spacing Marker
Wehr Machine Racing Products
$15.00
Tool marks hole spacing 1"-6" with both a hole and a point. Edge spacing of 1/4" and 1/2". Comes with a 1"-4" mini version for hard to reach areas.