Shock Mounts

Steel Shock mount extension bolts into your existing mount on your chassis and extends the shock 2''. Comes with WM148SS shock bolt.

Shock Mount, Clamp-On, Steel, Black Powder Coat, 1-1/2 or 1-3/4 in OD Tube, Each

Coil over Mount, Right Side, 1/8″ Steel

Radius Coil Over Mount, Right Side, Radius to fit 1 1/2″ Tubing

Elongated Coil Over Mount, 4 Mounting Positions, 1/8″ Steel, Fits 1 5/8″ Tubing, 4 holes are 1″ center to center, 7″ Length, Formed at 90 degrees, Hardware included (Bolt, Lock Nut, Plated Spacer)

Lower Control Arm Shock Mount, 1/8″ Steel with 1/2″ Welding Bushing

Radius Coil Over Mount, 1/8″ Steel, 1″ Gap

SHOCK BRACKET, 1/8″ STEEL, 1/2″ HOLES, PAIR

Our shock mount screw jack has a narrow steel shock mount welded to a 9'' screw jack. This is our 1'' coarse thread and comes with WM148SS shock bolt.

This is our new long steel shock bolt with points. Same design as our WM148SL bolt, but we added a point at centerline on each end to easily measure center to center on your shock! Bolt is 2-3/4" long and 1/2"-13 thread.

These are a cross between a bolt and a shock pin. Don't trust the pin? These use a nut, like a bolt would. Spacer part is machined on like the pins, thread is 1/2'' -13 coarse. 2-1/8'' short steel bolt.

Zinc Plated Steel Spacer Bushings, 3/4″ OD, 1/2″ ID