20 TOOTH HTD PULLEY

20 Tooth HTD Pulley used on Small Block Chevy mandrel drive kits (KSD1025 & KSD1039). Drive: 1.00" ID with 1/8" keyway. Construction: Aluminum with hardcoat anodized finish. 

40 TOOTH HTD PULLEY

40 Tooth HTD Pulley fits all belt driven KSE Tandem and TandemX Pumps. Drive: 5/8" ID with 3/16" keyway. Construction: Hardcoat anodized, billet aluminum. Includes: Pulley, 3/16" straight key, and set screws. Typical front drive or rear bell housing...

40T PULLEY GUIDE SET

40 tooth pulley / belt guide set for KSE 40 tooth pulley (KSD1019). Billet aluminum construction. Includes: front guide, rear guide, and mounting screws. Compatible with all belt driven KSE Tandem & TandemX Pumps.

600 X 20MM HTD DRIVE BELT BERT/BRIN

HTD Drive Belt, 600 mm Long, 20 mm Wide, 8 mm Pitch

624 X 20MM HTD DRIVE BELT BERT/BRINN

8MM HTD Drive Belts

High Torque Drive Belts 20mm wide Round teeth for superior drive Capability  

ALUMINUM LIGHTWEIGHT POWER STEERING RESERVOIR W/ CAP

Aluminum Can. 8" total height, 3" can diameter. -10AN Bottom port. -6AN Side return.  Includes aluminum mounting bracket.  3lbs total weight. 

BELT DRIVE TANDEM X PUMP

Belt drive TandemX Pump (All-In-One Power Steering and Fuel Pump). The belt drive TandemX Pump is popular for both modified and late model applications. This pump is compatible with both alcohol and gas race fuels - see recommended fuel section sizing...

BLOCK MOUNT STEERING PUMP WITH V-BELT PULLEY - RESERVOIR

Power Steering Pump Complete With V-Belt Pulley & Reservoir TankDesigned For Use With Fast Ratio Steering Boxes And Steering Quickeners-6an Inlet And Outlet Fittings1300PSI Power Steering PumpLightweight Aluminum Pump HousingLightweight Aluminum...

BLOCK-MOUNT POWER STEERING PUMP WITH V-BELT PULLEY

Power Steering Pump Complete With V-Belt PulleyDesigned For Use With Fast Ratio Steering Boxes And Steering Quickeners-6an Inlet And Outlet Fittings1300PSI Power Steering PumpLightweight Aluminum Pump HousingLightweight Aluminum Pulley

Head Mount for KSE Pumps

KSE’s new Direct Head Mount Kit was designed to simplify Tandem Pump mounting for crate motor applications requiring "front engine installation” (i.e. IMCA A-Mods). This Direct Head Mount Kit also works with many SBC applications with heads...

KSE SINGLE BELT DRIVE KIT

HTD single belt drive kit for V-belt driven water pump (most popular). Typical for IMCA type modified applications. Compatible with all KSE Tandem & TandemX Pumps. See photo for complete parts list. Tandem Pump mounting bracket / kit sold seperately...